Entamers of the major structural protein VP1. A, B: Two orientations

Entamers of the major structural protein VP1. A, B: Two orientations of VP1 pentamers with tyrosines (blue) exposed on the surface of VP1 loops. Program: PyMOL Version 0.99rc6, DeLano Scientific LLC, 2006, http://www.ncbi.nlm.nih.gov/ pubmed/. doi:10.1371/journal.pone.0049226.gPreparation of the TecophilicH and PCL nanofiber materialsNanofiber materials were produced using the NanospiderTM electrospinning technology [41]. The solution used to prepare the TecophilicH nanofiber material (8 in DMAc:toluene, 2:1 w/w)Virucidal Nanofiber Textilescontains 1 wt TPP, 0.01 wt TEAB and 98.99 wt TecophilicH. The solution used to prepare the PCL nanofiber material (15 in formic:acetic acid, 1:3 w/w contains 1 wt TPP and 99 wt PCL.medium (DMEM) supplemented with 2 mM glutamine and 10 fetal calf serum (FCS). Mouse polyomavirus (strain A2) was propagated for 7 days in whole mouse 23727046 embryo cells (0.05 PFU per cell). Virions were purified according to Turler and Beard [44]. ?Absorption and fluorescence spectroscopyThe UV/VIS absorption and fluorescence spectra were buy Met-Enkephalin recorded on Perkin Elmer Lambda 35 and Fluorolog 3 (Horiba Jobin Yvon) spectrophotometers, respectively. The samples were excited at the band maximum of TPP (413 nm).AntibodiesTwo different primary antibodies were used: a mouse monoclonal antibody against the mouse polyomavirus VP1 protein [43] and a rat monoclonal antibody against the mouse polyomavirus large T (LT) antigen [45]. Alexa Fluor 488 (green)-conjugated goat anti-mouse or donkey anti-rat immunoglobulin antibody was used as a secondary antibody.O2(1Dg) phosphorescenceThe nanofiber materials were excited using a Lambda Physik FL 3002 dye laser (425 nm, pulse width 28 ns). Time-resolved near-infrared phosphorescence of O2(1Dg) at 1270 nm was observed at a right angle to the excitation pulse using a homemade detector unit (interference filter, Ge diode Judson J16-8SP-R05MHS). The incident energy used is the region where the intensity of a phosphorescence MedChemExpress Tetracosactrin signal is directly proportional to the incident energy (less than 1 mJ). A singlet oxygen signal was corrected using detector responses in vacuum to eliminate fluorescence and scattered light.Treatment of the mouse polyomavirus on the surface of nanofiber textiles doped with TPPMouse polyomavirus in DMEM (100 ml; 16105 plaque forming units (PFU)) was dropped onto 1.0 cm2 of the nanofiber textile (polyurethane TecophilicH or PCL), placed on Parafilm in a dish cooled by ice and irradiated (as described above) or kept in the dark. The liquid containing the virus was collected from the nanofiber textiles; 26100 ml of DMEM was added to extract the remaining virus; and the combined virus fractions were transferred to a 24-well dish containing 3T6 fibroblasts grown on coverslips.Singlet oxygen-mediated delayed fluorescenceSODF was recorded using an LKS 20 kinetic spectrometer (Applied Photophysics, UK). The samples were excited with the same laser that was used for phosphorescence measurements [30,31]. The fluorescence time profiles were recorded at 460 nm using an R928 photomultiplier (Hamamatsu). SODF was calculated as the difference between TPP fluorescence in an air (oxygen) atmosphere and in a vacuum.Treatment of the baculoviruses on the surface of nanofiber textiles doped with TPPBaculoviruses in TMN H insect medium (Sigma) (25 or 50 ml; approx. 56104 PFU) were applied to nanofiber textiles and treated as described above. The liquid containing the virus was then collected fro.Entamers of the major structural protein VP1. A, B: Two orientations of VP1 pentamers with tyrosines (blue) exposed on the surface of VP1 loops. Program: PyMOL Version 0.99rc6, DeLano Scientific LLC, 2006, http://www.ncbi.nlm.nih.gov/ pubmed/. doi:10.1371/journal.pone.0049226.gPreparation of the TecophilicH and PCL nanofiber materialsNanofiber materials were produced using the NanospiderTM electrospinning technology [41]. The solution used to prepare the TecophilicH nanofiber material (8 in DMAc:toluene, 2:1 w/w)Virucidal Nanofiber Textilescontains 1 wt TPP, 0.01 wt TEAB and 98.99 wt TecophilicH. The solution used to prepare the PCL nanofiber material (15 in formic:acetic acid, 1:3 w/w contains 1 wt TPP and 99 wt PCL.medium (DMEM) supplemented with 2 mM glutamine and 10 fetal calf serum (FCS). Mouse polyomavirus (strain A2) was propagated for 7 days in whole mouse 23727046 embryo cells (0.05 PFU per cell). Virions were purified according to Turler and Beard [44]. ?Absorption and fluorescence spectroscopyThe UV/VIS absorption and fluorescence spectra were recorded on Perkin Elmer Lambda 35 and Fluorolog 3 (Horiba Jobin Yvon) spectrophotometers, respectively. The samples were excited at the band maximum of TPP (413 nm).AntibodiesTwo different primary antibodies were used: a mouse monoclonal antibody against the mouse polyomavirus VP1 protein [43] and a rat monoclonal antibody against the mouse polyomavirus large T (LT) antigen [45]. Alexa Fluor 488 (green)-conjugated goat anti-mouse or donkey anti-rat immunoglobulin antibody was used as a secondary antibody.O2(1Dg) phosphorescenceThe nanofiber materials were excited using a Lambda Physik FL 3002 dye laser (425 nm, pulse width 28 ns). Time-resolved near-infrared phosphorescence of O2(1Dg) at 1270 nm was observed at a right angle to the excitation pulse using a homemade detector unit (interference filter, Ge diode Judson J16-8SP-R05MHS). The incident energy used is the region where the intensity of a phosphorescence signal is directly proportional to the incident energy (less than 1 mJ). A singlet oxygen signal was corrected using detector responses in vacuum to eliminate fluorescence and scattered light.Treatment of the mouse polyomavirus on the surface of nanofiber textiles doped with TPPMouse polyomavirus in DMEM (100 ml; 16105 plaque forming units (PFU)) was dropped onto 1.0 cm2 of the nanofiber textile (polyurethane TecophilicH or PCL), placed on Parafilm in a dish cooled by ice and irradiated (as described above) or kept in the dark. The liquid containing the virus was collected from the nanofiber textiles; 26100 ml of DMEM was added to extract the remaining virus; and the combined virus fractions were transferred to a 24-well dish containing 3T6 fibroblasts grown on coverslips.Singlet oxygen-mediated delayed fluorescenceSODF was recorded using an LKS 20 kinetic spectrometer (Applied Photophysics, UK). The samples were excited with the same laser that was used for phosphorescence measurements [30,31]. The fluorescence time profiles were recorded at 460 nm using an R928 photomultiplier (Hamamatsu). SODF was calculated as the difference between TPP fluorescence in an air (oxygen) atmosphere and in a vacuum.Treatment of the baculoviruses on the surface of nanofiber textiles doped with TPPBaculoviruses in TMN H insect medium (Sigma) (25 or 50 ml; approx. 56104 PFU) were applied to nanofiber textiles and treated as described above. The liquid containing the virus was then collected fro.